UIY Surface Mount Isolator and Circulators , its product design is small, easy to install, reflow soldering, and its high frequency and multi-frequency range can be selected deep Loved by the majority of customers.
The Surface Mount Isolator/Circulator is said to be easy to install because it does not require too many complicated installation skills and wiring, and only needs to be soldered and pasted on the board that needs to be applied to it.
So how to operate the application and installation of surface mount products, I will introduce to you today.
The Surface Mount Circulator can be installed by reflow soldering. About its pad design: First of all, according to its pin size, each pin can be made a pad. For example, the Circulator pin is Φ1.2mm, we can make a 1.5mm pad: then make a pad at the bottom, and ground the bottom (As shown below).
Note: There should be no too much solder paste, so as to avoid the solder paste overflowing around after the Circulator is put on, which may cause a short circuit at the bottom of the three pins.
In addition, the installation method of the surface mount isolator and the surface mount circulator are the same.
Recommended for small size Surface Mount Isolator/Circulator
01
Surface Mount Isolator |
|
Model: UIYSI12A |
Forward Power: 30W |
Freq.Range: 0.7-10.0GHz |
Reverse Power: 10W |
IL.: 0.3dB |
Connector Type: SMT |
Isolation: 23dB |
Temp.: -40~+90°C |
VSWR: 1.2 |
Dimension LxWxH: Φ12.7×8mm |
Product Picture
RF Characteristics
Mechanical Drawing
02
Surface Mount Circulator |
|
Model: UIYSC9B |
Forward Power: 30W |
Freq.Range: 4.8~12.0GHz |
Reverse Power: 30W |
IL.: 0.4dB |
Connector Type: SMT |
Isolation: 20dB |
Temp.: -20~+60°C |
VSWR: 1.25 |
Dimension LxWxH: Φ9×6.5mm |
Product Picture
RF Characteristics
Mechanical Drawing